Treadmill Display Error

🛠️ Treadmill Error Code Troubleshooting Guide

(Provided by [Your Treadmill Service Company])

⚠️ Please Note:

Error codes may vary depending on the treadmill brand and model. We strongly recommend referring to your equipment’s user manual or contacting the manufacturer for the most accurate diagnosis.

The guide below is for general reference purposes based on common industry standards.

🔧 Common Error Codes & Their Meanings

E01 – Communication Failure

• This error typically indicates a failure in communication between the console board and the control board.

  Possible Causes:

  1.Faulty data cable

  2.Malfunctioning console board or control board

• ✅ Recommended Actions:

  1. Replace the data cable and test the machine.

  2. If the issue persists, replace the control board.

E02 – Control Board or Motor Issue

• This error suggests a problem with either the control board or the drive motor.

• ✅ Recommended Actions:

  1. Test the motor to ensure it's functioning properly.

  2. If the motor is operational, replace the control board.

E03 – Speed Sensor or Control Board Fault

• Two potential scenarios:

  1. Motor starts briefly and stops, then E03 appears — likely a speed sensor issue.

  2. Motor doesn’t start at all and E03 appears — likely a control board issue.

• ✅ Recommended Actions:

  1. Test the motor.

  2. If the motor is working:

     • Replace the speed sensor

     • If still unresolved, replace the control board

E04 – Overcurrent Protection / Burnt Component

• Typically indicates overcurrent or a burnt component on the control board.

• ✅ Recommended Actions:

  • Inspect and replace damaged components, or replace the entire control board.

E05 – Current Overload or Speed Instability

• Related to unstable speed or a current overload.

• ✅ Recommended Actions:

  • Check and reseat all control board connections.

  • Replace control board if the issue continues.

E06 – Motor Overload

• Often due to a motor strain or resistor failure on the control board.

• ✅ Recommended Actions:

  1. Test the motor’s operation.

  2. If the motor is fine, replace the current limiting resistor or the entire control board.

E07 – Console Board or Cable Fault

• Usually points to a fault in the console board or the data cable.

• ✅ Recommended Actions:

  • Replace the console board or test with a new data cable.

E08 – Lift Motor Control Error

• Indicates a possible issue with the incline motor or its control mechanism.

📘 Important:

Because each treadmill brand uses its own error code definitions, the above information may not be a perfect match for your specific model. Hence we suggest to get professional company like us and we will be happy to resolve your treadmill issue. To discuss your treadmill issue and fix a visit of our technician , kindly find below mode of communication.

Hot Line - 8981326760